Backflow Replacement

Rust and corrosion, along with worn-out or non-replaceable parts typically dictate when the replacement of backflow device is necessary. A backflow device normally will need to be replaced every 10-15 years. However, with the state of California lead free law (AB 1953) that went into effect in January 2010 and the new Federal Law in 2014, the backflow device may be required to be replaced when failed. All state and federal laws are enforced by the water purveyor and must be met to be in compliance.

When it comes to larger devices (3"- 12" backflows) Bay Area Backflow Inc's. experience and attention to detail will provide you with a backflow replacement or installation that is right for your specific application.

Choosing the correct backflow assembly device that will provide you with years of reliable service and low-cost maintenance is our priority. Typically a less expensive device to install is more costly to repair in the future. We will be happy to discuss the options that are available to you.

Bay Area Backflow Inc. has a designated backflow installation team with over 39 years of experience. Our fully equipped installation truck is equipped with a hoist that will lift up to 6000 lbs, has an on board generator, air compressor, and all the necessary tools to complete the job. This allows us to work safely, professionally and quickly to install or replace the backflow assemblies with less down time to your tenants or residents.

If you are looking to save money and water-shut down time is a concern for installations and/or replacements we are the right company for you. Contact us and we will make all the essential recommendations for your job and provide you with a competitive quote.

---